Brighter Image Dental Lab provides two impression trays and three packages of impression material. Your impressions are used to create a custom mould to make your hand made custom mouthpieces. Consult your dentist before making impressions if you have gum disease, loose crowns, loose fillings, decayed teeth or gum problems.
Scrub and rinse hands before beginning.
1. Remove one catalyst paste and one base paste and mix the two together by rolling and kneading in your hands until blended. Do not mix for more than one minute or the material will harden.
2. Roll the material and press to shape to the width and length of the tray.
3. Center the loaded tray over the upper teeth. Start at the back and work your way forward pressing firmly with your fingers so you can feel the material flow over your teeth and gums. Do Not Bite Down - Gently hold in place with your fingers. The impression material will extrude through the holes in the tray. Keep the impression in place for about 30 seconds, then remove carefully. THE TOTAL AMOUNT OF TIME TO MAKE YOUR IMPRESSIONS IS ABOUT 90 SECONDS (1 min 30 seconds) EACH. DO NOT remove the impression from the tray.
4. Check to make sure that you can see the impressions of your teeth in the impression putty. In case of error, you may use the tray again. An extra set of impression material is included.
5. To make the impressions for the lower teeth, repeat steps 2-4. Place the tray over the lower teeth. Remember not to bite down.
6. Let the trays harden for about 20 minutes, then rinse gently under cold water.
7. Fill out the address card (attached to system box flap) and place the impressions and card in the pre-addressed packing envelope and mail. Brighter Image Dental Lab will make your hand made custom mouthpiece in their state-of-the-art dental laboratory and send them back to you within 24 hours.
8. Bookmark this site so that you don't have to search for Teeth Whitening to return and check your order status or contact us to reorder.
You found us by searching for Teeth Whitening
Save Even More